Zed-3 GS8 Manuel d'utilisateur télécharger pdf (Page 1)

Quick Start Guide, document 96-00523-07 Page 1 of 5

Zed-3

501 Valley Way

Milpitas CA 95035

USA

Voice: +1-408-587-9333

Fax: +1-408-586-9038

www.zed-3.com

GS8 Modular Gateway

Quick Start Guide, document 96-00523-07

1 Verify Shipment Contents

Check the “Packing List (GS8)” document enclosed with the GS8 modular gateway to confirm that you

have received all the items listed. If you suspect that there are discrepancies with the items or that the

equipment is not fully functional, contact your Zed-3 sales representative immediately.

2 Hardware Installation

2.1 Place the GS8 modular gateway on a sturdy surface such as a table or a rack.

2.2 Connect one end of the ethernet cable to the LAN port located on the back and the other end to

the network, typically through a router or a switch.

2.3 For a CDMA or GSM module, carefully insert and lock the SIM card into the provided bracket.

Warning Take great care to prevent damaging the module with ESD.

2.4 Insert the CDMA, GSM, or FXO module into an empty slot and tighten the screws by hand.

Warning Never install or remove a module when power is turned on the GS8 modular gate-

way

2.5 Connect the power cord to the power port located on the back and the power plug to an outlet.

Verify the Power LED on the front is illuminated green.

3 Initial Login

By factory default, the GS8 modular gateway is assigned the IP address 192.168.0.100. You should assign

a static IP address to the GS8 modular gateway or alternatively allow your DHCP server to assign an IP

address to it. You can reset the IP address to the factory default by pushing the Reset button located on

the back for 6 seconds with power on.

Warning The Reset button resets all configurations to default, not only the IP address.

1 2 3 4 5

Résumé du contenu

Page 1 - GS8 Modular Gateway

Quick Start Guide, document 96-00523-07 Page 1 of 5Zed-3501 Valley WayMilpitas CA 95035USAVoice: +1-408-587-9333Fax: +1-408-586-9038www.zed-3.comGS8 M

Page 2 - 5 Upgrading the Firmware

Quick Start Guide, document 96-00523-07 Page 2 of 5GS8 Modular Gateway3.1 You cannot login to the GS8 Administration UI if the PC IP address does not

Page 3

Quick Start Guide, document 96-00523-07 Page 3 of 5GS8 Modular Gateway6 Setting the GS8 Modular Gateway to Work with your IP PBX6.1 Login to the GS8

Page 4

Quick Start Guide, document 96-00523-07 Page 4 of 5GS8 Modular Gateway• NAT Traversal Mode: Set to None unless the GS8 modular gateway and IP PBX are

Page 5 - 1-408-587-9333

Quick Start Guide, document 96-00523-07 Page 5 of 5GS8 Modular Gateway7.6 Register Address: Enter the IP address and port number of the GS8 modular ga